Konica Minolta 7033 Instruction Manual page 225

Section 10 : Output Mode
Procedure
1. Press the OUTPUT button on the operation panel to display the Output Mode screen
2. Touch "
STAPLE SET ". The Staple Location Selection screen will be displayed.
3. Touch the desired key among the eight keys on the Staple Location Selection screen
to select the staple location. See the previous page for reference.
4. Touch "
OK " on the Staple Location Selection screen to return to the Output Mode
screen. The " STAPLE " and " SORT " keys are highlighted.
5. Touch "
TRAY 2 " or " TRAY 3 ".
Advice
Do not touch " TRAY 1
4. Touch "
OK " on the Output Mode screen to complete setting and return to the Basic
screen.
5. Select additional copying features, as desired.
6. Enter the desired print quantity.
7. Position original(s) FACE UP in the RADF. 50 originals can be set.
When using Platen store mode, position original FACE DOWN on the platen glass
and touch " SCAN " on the Basic screen to scan.
Advice
Do not scan more than 51 images.
8. Press the START PRINT button to begin copying in Staple-sort mode.
CAUTION: Paper Capacity of the Finisher
The capacity of the Finisher exit tray is listed below. When the total number of
copies in the copy run exceeds the stated capacity, be sure to unload the exit
tray whilst the copier is still copying. Failure to do so will cause the copier to
jam. The following capacity is for 80g/m
Staple-Sort Mode
Tray 2/3 : 500 sheets (A4R, A4, B5R, B5, 8.5"x11"R)
300 sheets (A3, B4, F4/8.5"x13", A5R)
CAUTION: Finisher Operation
DO NOT INSERT your finger into the two staple driving portions or into the
grooves of the paper exit lever, otherwise you may be injured.
To avoid injury when the Finisher middle exit tray moves up and down, DO
NOT PUT your hand into the two portions of the closing area.
" to select the Staple-sort mode.
2
1. Finisher Specifications (continued)
paper.
Finisher
10 - 11