Konica Minolta 7033 Instruction Manual page 142

Section 8 : Special Copying : Page Editing
Incompatible
If any of the following copying conditions are going to be set, the Chapter copying
may be cancelled or the key concerned on the screen may become faint, not allowing
setting.
1s1
2s1
Image quality (Very high)
Sheet/Cover insertion
Combination
OHP interleave
Procedure
z Place Original(s)...FACE DOWN
1. Close the RADF securely and press the AUTO RESET button to set the RADF mode.
2. Press the APPLICATION button on the Operation panel to display the Application
Selection screen.
3. Touch " Chapter " key. The Chapter Insertion Setting screen will be displayed.
Application Selection screen
4. Enter the page number of the title page.
(1) Use the Ten key on the Operation panel to enter the page number of the title page.
The entered page number will be displayed on the screen.
Touch " SET " key to fix the entry, or " DELETE " key to clear the entry.
(2) Repeat this for each title page number you want to appear on the right side.
You can set up to 15 entries within p. 1 to p. 999.
Having Problems?
To clear an incorrect entry, touch "
button on the Operation panel, touch "SET" key and re-enter the correct page number.
Advice
• When the page number specified is larger than the total original page count, the
entry will be invalid.
• Chapter insertions occur in sequence even if original page numbers are entered
from the smaller page number.
• You cannot enter the same page number twice.
Advice
To return to the original condition set before change, touch "
(3) Touch " Booklet " key on the Chapter Insertion Setting screen to use this function.
To change the selection of paper tray for copying title page, touch " Copy Insertion "
key on the screen.
(4) When all entries are made, touch " OK " key.
Image insert
Dual page
Repeat
Auto layout
Thin/Thick paper
Non image area erase
Chapter Insertion Setting screen
" key on the screen or the CLEAR QTY.
DELETE
3. Chapter (continued)
" key.
CANCEL
8 - 15
Chapter