Konica Minolta 7033 Instruction Manual page 253

Section 11 : Key Operator Mode
Magnification [2]
PRESET and USERSET ratios are used to reduce and enlarge the original image to
accommodate copy paper size, and are available when Lens Mode is selected from the
Basic Screen. These ratios may be changed by the key operator as shown below.
Setting options: User Set or Preset ratio
Default setting: USERSET1: 4.00
USERSET2: 2.00
USERSET3: 0.50
Key Operator Mode screen
Procedure
1. While pressing HELP button, turn power ON. Enter a 4-digit key operator password,
then touch " OK " to display the Key Operator Mode screen.
Advice
If an invalid Key operator password is entered, continue by entering the valid 4-digit
password.
2. Touch "
3. Preset Key " to display the Preset Key Setting Menu screen.
3. Touch "
2. Magnification " to display the Userset Magnification Setting screen.
4. Touch "
USERSET " you want to change, then enter a ratio from 0.25~4.00, using the
keypad.
If a ratio under 0.25 is entered, 0.25 will be displayed.
If a ratio over 4.00 is entered, 4.00 will be displayed.
5. Touch "
OK " to complete the setting and return to the Preset Key Setting Menu
screen.
6. If no further changes are required, proceed to step 9 .
7. If other preset key setting changes are required, touch desired key, from
8. If no other preset key settings are required, touch "
Operator Mode screen.
9. Turn power OFF.
10. Turn the copier power switch back ON to perform copying operations.
11 - 18
Preset Key Setting Menu screen
4. Preset Key [3] (continued)
Userset Magnification Setting screen
RETURN " to restore the Key
[1] ~ [2] .