Face Up Mode - Konica Minolta 7033 Instruction Manual

Section 10 : Output Mode

Face Up Mode

In the normal exit mode, i.e., without Face Up mode selected, copies exit to the exit tray
in the same order as the originals. In the simplex mode, for example, every sheet exits
face down, and in the duplex mode, odd numbered sides exit face down. When the speedier
Face Up mode is selected, copies exit to the upper tray of the Finisher in the reverse
order, with simplex sheets and odd numbered duplex sheets face up.
Face Up Mode Specifications
Exit tray
Paper size
Paper capacity
Advice
* : A5 size paper is available in horizontal feed (
Incompatible
Sort
Staple-sort
Advice
• When using platen glass in simplex copying, place the originals in reverse order to
get effective results.
• Using Multi-sheet bypass tray automatically sets the copier to be in Face up mode.
If you desire to release this setting, contact your Service Centre.
Operation panel
Procedure
1. Press the OUTPUT button to display the Output Mode screen.
2. Touch "
TRAY1 " and " FaceUP TRAY 1 ".
In this case, the copied sets will be sorted automatically. Touch " GROUP " to output
in Group mode.
3. Touch "
OK " to complete setting and return to the Basic screen.
4. Select additional copying features, as desired.
5. Enter the desired print quantity.
10 - 12
: Upper (TRAY1) exit tray only
: A3, B4, F4/8.5"x13", A4R, A4, B5R, B5, A5R*,8.5"x11"R,
8.5"x11"
: Upper exit tray
100 sheets (A3, B4, F4/8.5"x13", A4R, A4, B5, B5R, A5R*,
8.5"x11"R, 8.5"x11")
10 sheets (thin/thick paper, OHP transparency film, etc.)
OUT PUT
1. Finisher Specifications (continued)
) only.
Output Mode screen