Konica Minolta 7033 Instruction Manual page 149

Section 8 : Special Copying : Page Editing
Supplement 1: Using Store mode
RADF store mode:
To copy a set of more than 50 originals, use RADF store mode. Touch and highlight the
" Store Mode " key on the Application Selection screen. See p. 7-8 to p. 7-10 for details.
Please Be Reminded!
Divide the originals into blocks not exceeding 50 sheets and load them from the block
with the first page.
Platen store mode:
To copy originals that cannot be fed through the RADF onto both sides of copy paper, use
Platen store mode. Touch and highlight the " Store Mode " key on the Application Selection
screen. See p. 7-4 to p. 7-7 for details.
Supplement 2: Checking copying conditions/printed copies
1. Press the CHECK button to display the Check screen.
2. Check the current copying conditions on the Check screen.
3. Touch "
PROOF COPY " key on the Check screen to make a proof copy.
When completed, touch " EXIT " key to return to the Basic screen.
See p. 7-22 to p. 7-27 for details.
v Start Copying
Press the START PRINT button. Originals loaded on RADF
are all scanned and discharged, then output job starts in
succession.
When using Store mode, press the START PRINT button to
start the output job.
To stop copying, press the STOP/CLEAR button. Scanned
data in the memory will be cleared.
After completion of copying, all the data in the memory will
be cleared.
Having Problems?
The memory may be fully loaded to cause overflow during scanning. See p. 12-4 to p.
12-5.
8 - 22
4. Combination (continued)
ERROR
POWER SAVER
ON / OFF
2 3
INTERRUPT
5 6
STOP / CLEAR
8 9
0
CLEAR QTY. START PRINT