Printer Maintenance Mode - Konica Minolta BIZHUB 25E Field Engineering Manual

A transmission with PPR signal:
The error frame in fax reception is identified using the post-message signal and PPR signal.
TxFrame RxFrame
PPS MPS
PPR
In PPS signal FIF, the pages, blocks and frames are displayed one value less than the real value.
So in the above case:
Pages: 00 means one page
Blocks: 00 means one block
Frames: 0F means 16 frames
In PPR signal FIF, the error frame will be displayed with "1". In the above case the fist frame is "F0" and it
means there was an error from frame 4 to 7.

3.9 Printer maintenance mode

In case of followings, use this mode.
• When you have replaced the Fuser unit and/or Transfer roller.
• When "Checkout error : XX" message appear on the screen, access this mode to see the details.
3.9.1 When you replace the fuser unit or transfer roller
To access the printer maintenance mode:
1. Press <Mode>, <*>, <0>, <6>.
2. Press [Set Replace Counter].
3. Select the item you have replaced.
4. Press [Yes].
D A T A
BF 4F 00 00 0F
BC F0 00 FF FF FF FF FF FF FF FF FF FF FF FF FF FF
FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
3-74