Non-Sort Mode Using Primary (Main) Tray - Konica Minolta 7055 Instruction Manual

Non-Sort Mode Using Primary (Main) Tray

The Non-sort mode simply means that the offset-stacker finisher modes are not selected.
Copies will be stacked upon exit without being offset by sorted sets.
With the Primary (main) tray initially selected on the Output Mode Screen, FS-106/FS-
108BM outputs the printed sheets FACE DOWN in the proper order.
Paper size: A3, B4, F4, A4R, A4, B5R, B5, A5*, B6*, 8.5"x11"R, 8.5"x11"
Paper capacity for 80g/m
NOTES:
*: A5 or B6 paper is available in landscape orientation (
Go out
Procedure
1 To use the Non-sort mode, be sure the Output, Staple-sort, and Sort indicator lights,
located above each key, are off.
2 Enter the desired print quantity.
3 Position original(s) in the document feeder or on the platen glass, and make copying
selections, as required.
4 Press [ START PRINT ] to begin copying in Non-sort mode.
Copies will exit face down, with the page heading toward the front of the copier.
CAUTION:
When the finisher capacity is exceeded due to the print quantity selected, remove the
copied sets while the paper is exiting; otherwise mishandled paper will occur.
2
: 500 sheets A5*, B6*
2,000 sheets A4R, A4, B5R, B5, 8.5"x11"R, 8.5"x11"
(FS-106)
3,000 sheets A4R, A4, B5R, B5, 8.5"x11"R, 8.5"x11"
(FS-108BM)
1,500 sheets A3, B4, F4
OUTPUT
STAPLE SORT
SORT
Section 7 : Output Modes
) only.
3
2
1
3
2
1
7 7
Output Output
Modes Modes
Finisher
Specifications
Non-Sort
7 - 5