Setup; Setup 1: Assemble The Stand - Sony SDM-S75N User Manual

Real of the display
7 8 qs 9qd
7 AC IN connector (page 9)
This connector connects the power cord (supplied).
8 DVI-D input connector (digital RGB)
This connector inputs digital RGB video signals that comply
with DVI Rev.1.0.
9 HD15 input connector (analog RGB) (page 8)
This connector inputs analog RGB video signals (0.700 Vp-p,
positive) and sync signals.
0 Cable holder
(page 9)
This part secures cables and cords to the display.
qa Security lock hole
The security lock hole should be used with the Kensington
Micro Saver Security System.
Micro Saver Security System is a trademark of Kensington.
qs Audio jack for INPUT1
This jack inputs audio signals when connected to the audio
output jack of a computer or other audio equipment connected
to INPUT1.
qd Audio jack for INPUT2
This jack inputs audio signals when connected to the audio
output jack of a computer or other audio equipment connected
to INPUT2.

Setup

Before using your display, check that the following items are
included in your carton:
• LCD display
• Power cord
• Stand Base
• HD15-HD15 video signal cable (analog RGB)
• DVI-D video signal cable (digital RGB)
• CD-ROM (utility software for Windows/Macintosh, Operating
qa
Instructions, etc.)
• Warranty card
0
• Quick Setup Guide
The contents with
the models. For details, "Specifications" (page 20).

Setup 1: Assemble the stand

Do not press the LCD display when placing or raising the
display straight on a desk or a like.
It may affect the uniformity of the screen or damage the
LCD display.
(page 8)
x When using supplied stand
1
Open the carton and take out the stand base.
2
Confirm the supplied items.
• Stand Base (with the screw at the bottom side)
3
Place a soft mat or a kind on a flat surface like a
desk.
You may damage the LCD screen and the display itself if
putting the display directly on the desk.
4
Take the display out from the carton and then place
the frame of the laid display along the edge of the
desk.
The figure shows the height adjustable stand. If you use the
fixed stand, your last step of assembling procedure is Step 5.
Soft mat or a like
6
mark for specifications vary depending on
Stand
Display