Table of Contents
Advertisement
281
Sleep Mode
Sets the sleep mode to on or off. When
you set to "On;' the monitor enters into
power saving mode by tuming off the
backlight if there is no input signal from
the selected connector for more than 1
rninute.
Serial Rernote
Serial Remote
Selects the using rnode.
• Off: Disables the serial rernote
• RS-232C: Controls this unit via RS-
• Ethernet: Controls this unit via
Ethernet Setting
Sets the Ethernet.
• IP Address: Sets the IP Address.
• Subnet Mask: Sets the Subnet Mask.
• Default Gateway: Sets "On" or "Off'
• Address: Sets the Default Gateway.
• Save: Saves the conf
• Cancel: Returns to the previous
Custom Button
Assigns the function to the CUSTOM 1,
CUSTOM 2 or CUSTOM 3 button on
the front panel, and can set the
following functions to on or off.
• No Setting
• Scan Size
• Flip
• POP Sub Screen Position
• Gamma
• Mono
• Phase
• Chroma
• Brightness
• Contrast
Panel Display
Backlight
Adjusts the brightness of the display. A
higher setting increases the brightness
of the display, and a lower setting
darkens the display.
Monitor Information
Software Version
Displays the software version.
Submenu
Setting
• APA
Adjustment Using the Menus
function.
232C command.
Ethernet command.
of the Default Gateway.
rmed setting.
setting frorn the confirmed setting.
i
The Initial Setup menu is used to set the default preset
value.
Language
You can select the menu or message
language frorn the following languages.
• English: English
• i:pj:: Chinese
• B ;$:fü,t: Japanese
• Italiano: Italian
• Espaiiol: Spanish
• Deutsch: German
• Fran,;ais: French
• PycclillR: Russian
Port A Input Select
Sets the
when changing the input signal by
pressing the PORT A button. Set to
"Not Skip" or "Skip" for the SDI, DVI
D, HD 15, VIDEO, S-VIDEO connector.
Port B Input Select
Sets the
when changing the input signal by
pressing the PORT B button. Set to "Not
Skip" or "Skip" for the SDI, DVl-D,
HDIS, VIDEO, S-VlDEO connector.
Pattern Skip
Sets the pattern that is skipped when
changing the displaying pattern by
pressing the PIP/POP button on the
front panel while using multi-image
display. Set to "Not Skip" or "Skip" for
the PIPI, PIP2, POP!, or POP2 pattern.
PIP / POP
PIP Sub Screen
Sets the sub screen position for the
Position
multi-image display (PIP).
Set the position of the sub screen with
the "Lower Left;' "Upper Left;' "Upper
Right;' and "Lower Right" icons.
POP Sub Screen
Sets the sub screen position for the
Position
multi-image display (POP).
Set the position of the sub screen with
the "Right" and "Left" icons.
PORT AHD
Sets the HD clipping size for each port
Clipping Size/
when displaying multi-image display.
PORTBHD
Select from among "Normal;' "4:3, "
Clipping Size
"5: 4 ."
� Initial Setup menu
ilä
B��Ef
lnltlil Setup
l li.i Langu.g•
Engfüh
Submenu
Setting
input
connector that is skipped
input
connector that is skipped
Advertisement
Table of Contents
