Table of Contents
Advertisement
Submenu
Setting
Auto: The format and scan mode are
displayed for about 3 seconds
when the content of Status
Display is changed.
On: The format and scan mode are
always displayed.
Off: The format and scan mode are
not displayed.
Notes
Even if the setting is set to "Auto" or
"Off, " the flip pattern is available.
For details about the signal format,
refer to no signal and incompatible
signal displays.
Input
No signal
Non compatible
signal (except for
DVI-D, HDMI)
Non compatible
signal (DVI-D,
HDMI)
Language
You can select the menu or message
language from the following languages.
English: English
: Chinese
Italiano: Italian
Español: Spanish
Deutsch: German
Français: French
Power On Setting
Power On Mode
Selects the setting when the monitor is
turned on from the following settings.
Last: The setting when the monitor
was last turned off.
Default Setting: The setting that is
set in the default setting.
Preset A to T: The selected fixed user
setting.
User1 to 20: The selected user setting.
Logo
Select the logo when the power turns on
from among "On - 5sec, " "On - 10sec, "
"Off. "
Power Save
Energy Saving
Selects the energy saving mode.
Mode
Off: Turns the energy saving mode
off.
On: Dims the backlight.
Signal format
display
No Sync
Unknown
Out Of Range
: Japanese
Submenu
Setting
Sleep Mode
Sets the sleep mode to on or off. When
you set to "On, " the monitor enters into
power saving mode by turning off the
backlight if there is no input signal from
the selected connector for more than 1
minute.
Serial Remote
Serial Remote
Selects the using mode.
Off: Disables the serial remote
RS-232C: Controls this unit via RS-
Ethernet: Controls this unit via
Ethernet Setting
Sets the Ethernet.
IP Address: Sets the IP Address.
Subnet Mask: Sets the Subnet Mask.
Default Gateway: Sets "On" or "Off"
Address: Sets the Default Gateway.
Custom Button
Assigns the function to the CUSTOM 1,
CUSTOM 2 or CUSTOM 3 button on
the front panel, and can set the
following functions to on or off.
No Setting
Scan Size
Zoom
Flip
POP Sub Screen Position
Gamma
Mono
Phase
Chroma
Brightness
Contrast
Port C Display
Panel Display
Backlight
Adjusts the brightness of the display. A
higher setting increases the brightness
of the display, and a lower setting
darkens the display.
Initial Setup menu
The Initial Setup menu is used to make the basic settings
to use the unit.
Submenu
Setting
Default Preset
Sets the initial preset settings.
Select from among "Preset A" to "Preset
T. "
Language
You can select the menu or message
language from the following languages.
English: English
: Chinese
Italiano: Italian
Español: Spanish
Deutsch: German
Français: French
function.
232C command.
Ethernet command.
of the Default Gateway.
: Japanese
Adjustment Using the Menus
25
Advertisement
Table of Contents
