Sony SDM-S75N User Manual page 45

Symptom
Picture is fuzzy
Picture is ghosting
Picture is not centered or sized
properly (analog RGB signal only)
Picture is too small
Picture is dark
Wavy or elliptical pattern (moire)
is visible
Color is not uniform
White does not look white
Display buttons do not operate
( appears on the screen)
The display turns off after a while
Resolution displayed on the menu
screen is incorrect.
Displaying this display's information
While the display is receiving a video signal, press and
hold the MENU button for more than 5 seconds until the
information box appears.
Press the MENU button again to make the box disappear.
MENU
Example
INFORMATION
MODEL : SDM-S75A
SER. NO : 1234567
MANUFACTURED : 2005-52
Although the safety standard registered model name of this
display is SDM-S75 /S95 , the name of SDM-S75A/S95A/
S75D/S95D/S75E/S95E/S75F/S95F/S75N/S95N is used on sale.
If any problem persists, call your authorized Sony dealer and give
the following information:
• Model name
• Serial number
Check these items
• Adjust the brightness and contrast (page 14).
• Adjust the pitch and phase (analog RGB signal only) (page 14).
x Problems caused by a computer or other equipment connected, and not
caused by the display
• Set the resolution to 1280 × 1024 on your computer.
• Eliminate the use of video cable extensions and/or video switch boxes.
• Check that all plugs are firmly seated in their sockets.
• Adjust the pitch and phase (page 14).
• Adjust the picture position (page 14). Note that some video modes do not fill the screen to
the edges.
x Problems caused by a computer or other equipment connected, and not
caused by the display
• Set the resolution to 1280 × 1024 on your computer.
• Adjust the backlight (page 14).
• Adjust the brightness (page 14).
• Adjust the gamma using GAMMA menu (page 14).
• It takes a few minutes for the display to become bright after turning on the display.
• The screen might turn darker, depends on ECO mode you selected.
• Adjust the pitch and phase (analog RGB signal only) (page 14).
• Adjust the pitch and phase (analog RGB signal only) (page 14).
• Adjust the color temperature (page 14).
• If MENU LOCK is set to ON, set it to OFF (page 15).
xProblems caused by the connected computer or other equipment
• Set the computer's power saving setting to off.
• Depending on the graphics board setting, the resolution displayed on the menu screen may
not coincide with the one set on the computer.
• Detailed description of the problem
• Date of purchase
• Name and specifications of your computer and graphics board
• Type of input signals (analog RGB/digital RGB)
Model name
Serial number
Week and year
of manufacture
19
GB