Displaying The Forwarding Cache - Dell PowerConnect B-FCXs Configuration Manual

TABLE 162
This field...
Static ARP table size
Index
IP Address
MAC Address
Port

Displaying the forwarding cache

To display the IP forwarding cache, enter the following command at any CLI level.
PowerConnect# show ip cache
Total number of cache entries: 3
D:Dynamic
W:Wait ARP
1
2
3
Syntax: show ip cache [<ip-addr>] | [<num>]
The <ip-addr> parameter displays the cache entry for the specified IP address.
The <num> parameter displays the cache beginning with the row following the number you enter.
For example, to begin displaying the cache at row 10, enter the following command.
show ip cache 9
The show ip cache command displays the following information.
TABLE 163
This field...
IP Address
Next Hop
MAC
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
CLI display of static ARP table
Displays...
The maximum number of static entries that can be configured on the device using the
current memory allocation. The range of valid memory allocations for static ARP entries is
listed after the current allocation. To change the memory allocation for static ARP entries,
refer to "Changing the maximum number of entries the static ARP table can hold"
page 814.
The number of this entry in the table. You specify the entry number when you create the
entry.
The IP address of the device.
The MAC address of the device.
The port attached to the device the entry is for.
P:Permanent F:Forward
I:ICMP Deny K:Drop
IP Address Next Hop
192.168.1.11 DIRECT
192.168.1.255 DIRECT
255.255.255.255 DIRECT
CLI display of IP forwarding cache – Layer 3 Switch
Displays...
The IP address of the destination.
The IP address of the next-hop router to the destination. This field contains either an IP address
or the value DIRECT. DIRECT means the destination is either directly attached or the destination
is an address on this Dell PowerConnect device. For example, the next hop for loopback
addresses and broadcast addresses is shown as DIRECT.
The MAC address of the destination.
NOTE: If the entry is type U (indicating that the destination is this Dell PowerConnect device), the
address consists of zeroes.
Displaying IP configuration information and statistics
U:Us C:Complex Filter
R:Fragment S:Snap Encap
MAC
0000.0000.0000
0000.0000.0000
0000.0000.0000
26
on
Type Port Vlan Pri
PU n/a 0
PU n/a 0
PU n/a 0
877