Configuring Output Parameters; Preliminary Guidance; Define - Visonic PowerMaster-10 Installer's Manual

4.12 CONFIGURING OUTPUT PARAMETERS

4.12.1 Preliminary Guidance

This mode allows you:
a. Events/conditions selection under which PGM (programmable) output will function.
b. Selection of the internal siren or STROBE light (that will be activated according to system programming).
4.12.2 Define PGM
For the PGM output, you can select disable, turn on, turn off or pulse active (turn on for predefined period,
selected by PULSE TIME), as follows:
ARM AWAY (upon AWAY arming).
ARM HOME (upon HOME arming).
DISARM (upon disarming).
MEMORY (activated upon registration of an alarm in the memory, turned off upon memory clearing).
DELAY (during exit / entry delays).
KEYFOB (upon pressing the AUX button in the keyfob transmitter).
ZONES (by disturbance in each of 3 selected zones, irrespective of arming / disarming). If you select toggle,
the PGM output will be turned on upon event occurrence in these zones and will be turned off upon next
event occurrence, alternately.
LINE FAIL: PGM output is ON if telephone line is disconnected.
For PGM devices, you can select the following action:
LOCKOUT TIME - you can enter daytime limits between which PGM lighting devices controlled by sensors will
be off, even when the associated sensors are triggered.
A. To Configure Output Parameters
1.
05: OUTPUTS
2.
DEFINE PGM
3.
PGM: PULSE TIME
4.
pulse time 2s
or
5.
6.
PGM: BY ARM AWAY
7.
disable
or
8.
9.
PGM: BY ARM AWAY
10.
D-303145
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
There are two sub-menus "DEFINE PGM" and "PGM GENERAL DEF".
The PowerMaster-10 display will first read "DEFINE PGM".
Select between "pulse time 2s", "pulse time 30s", "pulse time
2m" and "pulse time 4m"
Select between "disable", "turn ON", "turn OFF" and "pulse
active".
71