5.1.3 Displaying Signal Strength Indication of All Devices
1.
07:DIAGNOSTICS
2.
WL DEVICES
3.
TEST ALL DEVICES
or
4.
SHOW ALL DEVICES
5.
Z01: 24hr: GOOD
Z01: NOW: NOT TST
6.
K01: 24hr: NONE
K01: NOW: NONE
5.1.4 Displaying Signal Strength Indication of RF Devices
1.
07:DIAGNOSTICS
2.
D-303145
The signal strength indications are as follows: "
"
" (the device operates in 1-way mode, or, the "NOW"
1-WAY
communication test failed); "
(results are shown without any performed test); "
enrolled – not networked); "
(result of the last 24Hrs without statistics).
Clicking the
takes you one level up with each click. Clicking the
take you to "
<OK> TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
The PowerMaster-10 display switches between the average signal
strength indication for the last 24 hours and the current signal strength
indications of the first device type.∗
Press the
button to view the signal strength indications for the
next device type.*
The signal strength indications are as follows: "
"
" (the device operates in 1-way mode, or, the "NOW"
1-WAY
communication test failed); "
(results are shown without any performed test); "
enrolled – not networked); "
(result of the last 24Hrs without statistics).
∗
Clicking the
to which the signal strength indications refer.
Clicking the
takes you one level up with each click. Clicking the
take you to "
<OK> TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
." (no communication); "
NO COM
" (keyfob 24Hr result); or "
NONE
button repeatedly at any stage in the procedure
".
." (no communication); "
NO COM
" (keyfob 24Hr result); or "
NONE
button will display the number and type of device
button repeatedly at any stage in the procedure
".
";
"; "
STRONG
GOOD
POOR
NOT TST
" (device is pre-
NOT NET
EARLY
button will
";
"; "
STRONG
GOOD
POOR
NOT TST
" (device is pre-
NOT NET
EARLY
button will
";
"
"
";
"
"
79