Closing The Control Panel; Supplying Power To The Unit; Inserting Backup Battery - Visonic PowerMaster-10 Installer's Manual

WARNING! When plugging SIREN & ZONE terminals back into place, be sure to align them carefully with the
pins on the PCB. Misaligned or reverse insertion of terminals may damage internal PowerMaster-10 circuits!

Closing the Control Panel

Control panel final closure is shown below.
1
To Close the Control Panel:
1. Close the front cover
2. Fasten the screws
Figure 3.2 - Final Closure

3.3 Supplying Power to the Unit

Connect power to the PowerMaster-10 temporarily (see Figure 3.3). Alternatively, you may power up from the
backup battery, as shown in Figure 3.3.
Disregard any "trouble" indications pertaining to lack of battery or lack of telephone line connection.
For Europe Safety Compliance:
a. The model shall be installed according to the local electrical code.
b. The circuit breaker shall be readily accessible.
c. The rating of the external circuit breaker shall be 16A or less.
d. The cables for the AC mains connection shall have an overall diameter of 13mm and 16mm conduit.
Please refer to Figure 4.3 "Power Cable Connection".

Inserting Backup Battery

Connect battery pack as shown in the next drawing.
D-303145 9