Configuring Swinger Stop; Enable Monitoring Of Activity At Home - Visonic PowerMaster-10 Installer's Manual

4.8.2 Configuring Swinger Stop

Swinger stop determines the number of times each zone is allowed to initiate an alarm within a single
arming/disarming period (including tamper & power failure events of detectors, PowerMaster-10, wireless siren,
etc.). If the number of alarms from a specific zone exceeds the programmed number, the control panel
automatically bypasses the zone to prevent recurrent siren noise and nuisance reporting to the Monitoring
Station. This temporary bypass will automatically terminate upon disarming, or 48 hours after it was initiated (if
the system remains armed).
Available options are: shut after 1 (default), shut after 2 (default in USA), shut after 3 and no shutdown.
Note: To comply with EN requirements, the swinger stop should be set to 3.
To Configure Swinger Stop
1.
03:CONTROL PANEL
2.
01:ENTRY DELAY 1
or
3.
13:SWINGER STOP
4.
shut after 1
or
5.
6.
13:SWINGER STOP

4.8.3 Enable Monitoring of Activity at Home

Here you determine the time limit for reception of signals from sensors used to monitor the activity of sick,
elderly or disabled people. If no sensor detects and reports movement at least once within the defined time limit,
a "not-active" alert is initiated.
Options: 3, 6, 12, 24, 48, 72 hours and no act disable (default).
To Configure Monitoring of Activity at Home
1.
03:CONTROL PANEL
2.
01:ENTRY DELAY 1
or
3.
21:NOT ACTIVE
4.
no act disable
or
5.
56
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "shut after 1", "shut after 2", "shut after 3"
and "no shutdown".
You can now press the
menu in "
03:CONTROL PANEL
" ".
<OK> TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "no act disable", "3 h", "6 h", "12 h", "24 h", "48 h",
and "72 h".
or button to program any other
" or press the button to take you to
D-303145