Zones / Devices; General Guidance; Adding A Wireless Device - Visonic PowerMaster-10 Installer's Manual

4.5 Zones / Devices

4.5.1 General Guidance

The ZONES / DEVICES mode enables the following functions:
- Defining default parameters common for each devices family.
- Adding new devices (enrolling) and defining their locations, zone type and chime zone.
- Deleting devices.
- Replacing devices.
- Modifying devices parameters.
Enrolling can be performed for Keyfobs (multi-button), keypads, wireless detectors, wireless sirens and repeaters.
Enrolling of proximity tags is performed via the KP-141 PG2 keypad only.
The control panel enables entering a device identification (ID) instead of enrolling an actual device. This enables
pre-enrolling off site.
Upon boot up, the control panel performs a synchronizing process with the devices that are enrolled in the control
panel. In this case, the control panel will display "SYNC WITH DEV" alternating with "PLEASE WAIT ..." on the LCD.
Refer to sections 4.5.2. to 4.5.4 for detailed instructions on Enrolling/Deleting a device.
Notes
- Keyfob enrolling can be performed also by the user (via USER SETTINGS menu).
- Wireless detectors, wired magnetic contact or any other contact can be enrolled in zones 1 - 30.
Before beginning, gather all the devices that you intend to enroll and make sure they all have batteries installed.
Your control panel must recognize the unique identification code (ID) of each such detector in order to supervise
them, receive their signals and respond accordingly.
• Before enrolling, the lens at the front of PIR and dual-technology sensors should be masked to prevent inadvertent
transmission.
• Make sure that magnetic contact transmitters are together with their magnets, to prevent them from sending
out alarm transmissions.

4.5.2 Adding a Wireless Device

This section describes how to add a new device to the PowerMaster-10 control panel.
Note: It is much easier to enroll the device while holding the device in your hand, close to the control panel.
A. To Add a Device
1.
02:ZONES/DEVICES
2.
ADD NEW DEVICES
3.
ENROLL NOW or
ENTR ID: XXX-XXXX
D-303145
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
You are now instructed to enroll the device.
Enter the 7-digit number printed on the back side of the device and press
.* / **
or
Perform the enrollment sequence for the specific device:
For most devices: Remove the device bracket or cover and press the
device's Enroll button continuously until the red & green LEDs turn ON
and then release. The PowerMaster-10 will indicate the result on its LCD
display.
For keyfobs: Press and hold the AUX
until the LED is constantly on, release the button and press it again. The
PowerMaster-10 will indicate the result on its LCD display.
For keypads: Press the AUX
5 seconds until the orange LED lights steadily and then release the
button. The PowerMaster-10 will indicate the result on its LCD display.
button on the selected keyfob
button on the selected keypad for about
21