Visonic PowerMaster-10 Installer's Manual page 46

5.
GSM RPRT RETRY
6.
4 attempts
7. or
8.
GSM RPRT RETRY
4.7.3.7 Configuring the Auto Test Report
Continue below from the previous section or repeat steps 1 to 4 of section 4.7.3.1 before continuing with the
following instructions:
REPORT EVENTS
or
1.
AUTO TEST TIME
2.
test time 12:00P
3.
AUTO TEST TIME
4.
AUTO TEST CYCLE
5.
test OFF
6.
or
7.
AUTO TEST CYCLE
8.
LINE FAIL REPORT
9.
PSTN
10.
D-303145
Here you determine the number of times the communicator will try to
report via a cellular group (GPRS, GSM and SMS) to the Monitoring
Station.
Select between "2 attempts", "4 attempts", "8 attempts", "12
attempts" and "16 attempts".
You can now press the
" menu, or press the
TIME
Here you determine the time at which the telephone line will be tested
and reported to the Monitoring Station.
Enter the auto test time.
Here you determine the time interval between consecutive telephone line
test messages sent to the Monitoring Station. The control panel performs
this at regular intervals to verify proper communications.
Select between "test OFF", "test every 1 d", "test every 2 d",
"test every 5 d", "test every 7 d", "test every 14 d", "test
every 30 d" and "test every 5 h".
Here you determine if the PSTN telephone line disconnection will be
reported or not and determine the delay between detection of line
disconnection and the failure reporting. If the telephone line is
disconnected, the event "tel line fail" will be stored in the event log.
button to take you to the "
button to take you to "
AUTO TEST
".
<OK> TO EXIT
45