Configuring A Duress Code - Visonic PowerMaster-10 Installer's Manual

To Configure Permissions for System Reset after an Alarm Event
1.
2.
03:CONTROL PANEL
3.
01:ENTRY DELAY 1
4. or
25:RESET OPTION
5.
user reset
25:RESET OPTION

4.4.6 Configuring a Duress Code

A duress alarm (ambush) message can be sent to the Monitoring Station if the user is forced to disarm the system
under violence or menace. To initiate a duress message, the user must disarm the system with the duress code
(2580 by default). Here you can change the code digits or enter "0000" to disable the duress feature. The system
does not allow the user to program the duress code saved in this memory location as an existing user
code.
Note: Duress Code is not applicable in the UK.
To Configure a Duress Code
1.
2.
03:CONTROL PANEL
3.
01:ENTRY DELAY 1
4. or
23:DURESS
5.
DURESS CODE 2580
23:DURESS
20
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "user reset" (default), and "engineer reset".
You can now press the
in "
03:CONTROL PANEL
".
EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Change the code or enter 0000 to disable the duress function.
You can now press the
" " or press the
03:CONTROL PANEL
".
EXIT
or button to program any other menu
" or press the
or button to program any other menu in
button to take you to "
button to take you to "
<OK> TO
<OK> TO
D-303145