Zone Types - Visonic PowerMaster-10 Installer's Manual

4.
Z01:ZONE TYPE
5.
12.Non-Alarm
6. or
3.Home Delay
7.
Z01:SET CHIME
8.
Chime off....
or
9.
melody-chime
10.
Z01:DEV SETTINGS
11.
NEXT device
12.
MODIFY SAME Dev.
13.
EXIT Enrollment
4.5.2.2 Configuring Device Parameters
Refer to the device Installation Instructions for detailed instructions on how to modify specific device settings for
each device

4.5.2.3 Zone Types

Upon enrollment of a new detector (marked "Zxx") you must select the proper zone type. The zone type determines
how the system handles alarms and other signals sent from the device.
A list of factory defaults is printed in Appendix D. You may fill out the blank columns even before you start and
proceed to program according to your own list.
D-303145
Select a zone type, or, enter the zone type number, for example, pressing
03 selects "3. Home Delay".*
To understand the behavior of each zone, see section 4.5.2.3 Zone
Types.
Press to change chime settings or press the
Select between "Chime off" and "melody-chime".
Note: In "melody chime" mode when a chime zone is triggered, a chime
melody is heard. Make sure the chime button
**
***
***
***
* For motion camera detectors, options "
" and "
Key 12.Non-Alarm
" " cannot be selected.
11.Arming Key
** To perform Device Settings refer to the Installation Instructions of the
relevant device.
*** When the PowerMaster-10 will read "
button to enroll the next device. When the PowerMaster-10 will
read "
MODIFY SAME Dev.
same device. When the PowerMaster-10 will read "
you can click the
10.Emergency
" cannot be selected. For PIR detectors, option
NEXT device
" you can click the
button to revert to "
ADD NEW DEVICES
button to skip.
is ON.
", "
11.Arming
" you can click the
button to modify the
"
EXIT Enrollment
".
23