Replacing A Device - Visonic PowerMaster-10 Installer's Manual

4.5.6 Replacing a Device

This feature is used for replacing a device that is enrolled in the system with another device of the same type
while keeping the same parameters of the original device. This can save valuable time, since instead of having
to delete the original device from the control panel, then to enroll the new device and then to set the device
parameters again – all this can now be performed in one procedure.
To Replace a Device
1.
02:ZONES/DEVICES
2.
ADD NEW DEVICES
or
3.
REPLACE DEVICES
4.
CONTACT SENSORS
or
5.
CONTACT SENSORS
6.
Z01: Contact Sens
ID No. 100-2340
or
7
8.
ENROLL NOW or
9.
ENTR ID:100-xxxx
DEVICE ENROLLED
Z01: Contact Sens
ID No. 100-2332
32
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select the desired device type to be replaced. Select between "CONTACT
SENSORS", "MOTION SENSORS", "SMOKE SENSORS", "TAGS(Proximity)",
"KEYFOBS", "KEYPADS" "SIRENS" or "REPEATERS", for example,
"CONTACT SENSORS".
The PowerMaster-10 display will read the name of the first enrolled
device of the selected type to be replaced alternating with the ID number
of the device. *
At this stage you can select another device of the same type (in this
example, contact sensor) to be replaced.
Enroll the new device, or, enter the last 4 digits of the ID number of the
new device.
The PowerMaster-10 display will read the result.** / ***
* The displayed (presently enrolled) device LED indicator blinks red.
** If the device was previously enrolled in the system, the PowerMaster-
10 display reads "
ALREADY ENROLLED
If the device ID number is invalid the PowerMaster-10 display reads
" ".
WRONG ID No
If the new device type is different from the existing device to be
replaced, the PowerMaster-10 display reads "
".
WRONG DEV.TYPE
D-303145
".