Visonic PowerMaster-10 Installer's Manual page 55

4.
Image forward
or
5.
View on arming
6.
Disable
7. or
8.
View on arming
C. To Configure the request of images by the Monitoring Station after an Alarm only
9.
View on arming
or
10.
View on alarm
11.
Always
or
12.
13.
View on alarm
D. To Setup Visual Verification for Personal Alarm and Fire Alarm Events
Here you determine whether to enable or disable the motion camera for taking pictures after a
Duress/Emergency/Fire/Panic alarm has been initiated.
1.
04:COMMUNICATION
2.
1:PSTN/GSM
54
Here you determine the status/statuses of the alarm system for the
PowerManage server to retrieve pictures.
Select between "Disable", "Enable all", "AWAY only", "HOME only",
"HOME & AWAY", "DISARM & AWAY", "DISARM & HOME" and "DISARM only".
*
* If an option other than "
" " - will open upon pressing the
View on alarm
button (see section "C. To Configure View on Alarm".
You can now press the
menu, or press the
Continue from the previous section.
Here you determine whether images sent to the PowerManage server
can be retrieved always, or, only up to a specific time period.
Select between "Always", "Alarm + 5 min." (images can be retrieved
for up to 5 min. following an alarm event), " Alarm + 15 min." (images
can be retrieved for up to 15 min. following an alarm event) and "Alarm
+ 1 hour" (images can be retrieved for up to 1 hour following an alarm
event).
You can now press the
" menu, or press the
CAMERA
".
EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
" is selected, an additional menu –
Disable
button to revert to the "
button to take you to "
<OK> TO EXIT
button to revert to the "
button to take you to "
or
"
5:MOTION CAMERA
".
5:MOTION
<OK> TO
D-303145