Configuring Bypassing Zones - Visonic PowerMaster-10 Installer's Manual

To Enable Quick Arm
1.
03:CONTROL PANEL
2.
01:ENTRY DELAY 1
or
3.
07:QUICK ARM
4.
quick arm OFF
or
5.
6.
07:QUICK ARM

4.9.5 Configuring Bypassing Zones

Here you permit either manual bypassing of individual zones (through the USER SETTINGS menu), or allow the
system to "force arm" (perform automatic bypassing) of open zones during the exit delay. If desired, press the
arming key again if you want to eliminate the protest tone that sounds during forced arming. If a zone is open
and forced arming is not permitted, "NOT READY" is displayed and the system does not arm (the "Sad Melody"
will sound). If "no bypass" is selected, neither manual bypassing nor force arming is allowed.
Options: manual bypass (default in USA), force arm and no bypass (default).
Note: To comply with EN requirements, "manual bypass" or "force arm" must be selected.
Note: The option "force arm" is not applicable in the UK.
To Configure Bypass
1.
03:CONTROL PANEL
2.
01:ENTRY DELAY 1
or
3.
08:BYPASS
4.
no bypass
or
5.
6.
08:BYPASS
64
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "quick arm ON", and "quick arm OFF".
You can now press the
menu in "
03:CONTROL PANEL
" ".
<OK> TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "manual bypass", "force arm" and "no bypass".
You can now press the
menu in "
03:CONTROL PANEL
" ".
<OK> TO EXIT
or button to program any other
" or press the
or button to program any other
" or press the
button to take you to
button to take you to
D-303145