Visonic PowerMaster-10 Installer's Manual page 38

GSM KEEP ALIVE
4.7.2.2 Configuring GPRS / BB Communicators
The GSM/GPRS module is capable of communicating with the Monitoring station receiver by GPRS, GSM Voice
and SMS Channels. Each of the channels can be separately enabled or disabled in order to allow or prohibit the
module from using it for the event reporting. If all channels are enabled, the GSM/GPRS module will always try
GPRS first. If fails, it will try GSM voice. If fails, it will try any other possible method and only then it will try SMS.
This is due to the fact that SMS the most unreliable option of communication. Disabling any of the GSM Module
channels will cause the module to use a different sequence than the one described above.
1.
04:COMMUNICATION
2.
1:PSTN/GSM
3.
2:GSM/GPRS
4.
GPRS REPORT
5.
disable
or
6.
7.
GPRS REPORT
8.
GSM REPORT
9.
disable
10. or
11.
GSM REPORT
12.
SMS REPORT
13.
disable
14.
or
15.
SMS REPORT
D-303145
You can now press the
or press the button to take you to "
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Here you determine whether the alarm system will report events to the
Monitoring Station via the GPRS Channel.
Select between "disable" and "enable".
Here you determine whether the alarm system will report events to the
Monitoring Station via the GSM Voice channel.
Select between "disable" and "enable".
Here you determine whether the alarm system will report events to the
Monitoring Station via the SMS Channel.
Select between "disable" and "enable".
button to revert to the "
<OK> TO EXIT
" menu,
AREA CODE
".
37