Visonic PowerMaster-10 Installer's Manual page 23

DEVICE ENROLLED
K01:Keyfob
Z01:Motion Sens
...........
S01:Siren
ID No. 120-5812
4.5.2.1 Assigning a Location, Zone type and Chime Option
B. To Assign a Location, Zone Type and Chime Option
The PowerMaster-10 system behavior is defined according to one of a number of zone types assigned to each of
the system's 30 (wireless & wired) zones.
Note: Steps 1 to 9 are applicable to detectors only.
Continue below from the previous section.
1.
Z01:LOCATION
2.
Front door
or
3.
Master Bdrm
22
The PowerMaster-10 display reads "
" if the device was enrolled manually by entering the ID number)
accepted
and the PowerMaster-10 display will then change to "
Z01:Motion Sens / S01:Siren"
device" and alternating with the device ID number.
However, if the device was previously enrolled in the system, the
PowerMaster-10 display reads "
You can now press the
type or press the
section 4.5.2.1) or press the
Repeat the above procedure for each device to be enrolled in the
PowerMaster-10 system.
Continue to section 4.5.2.1 Assigning a Location, Zone Type and Chime
Option.
When exiting "
INSTALLER MODE
displays the number of devices that need to be updated, as follows: "
".
UPDATING NNN
* If you enter the 7-digit number, you must physically install the device
to complete the procedure. If the device is not installed the system will
display the device as "
when reviewing memory content.
** If a hard wired device is being enrolled, enter 050-0001 for the ID
number.
Select a location, or, enter the location number, for example, pressing 22
selects "Master Bdrm" (for the complete list of locations that may be
selected, see section 4.5.2.4 Locations).
DEVICE ENROLLED
etc. depending on the type of enrolled
ALREADY ENROLLED
button to select the next available zone
button to move to the "
button to take you to "
" menu the PowerMaster-10 system
" (device is pre-enrolled)
Z02 NOT NETWORKD
" (or "
ID
K01:Keyfob /
".
" menu (see
LOCATION
".
<OK> TO EXIT
DEV
D-303145