•
Repeaters should be located high on the wall in mid-distance between the transmitters and the control
panel.
WARNING! To comply with FCC and IC RF exposure compliance requirements, the control panel should be
located at a distance of at least 20 cm from all persons during normal operation. The antennas used for this
product must not be co-located or operated in conjunction with any other antenna or transmitter.
3.2 Mounting the Unit
Required tool: Philips screwdriver #2.
PowerMaster-10 mounting process is shown in Figures 3.1 - 3.2.
Opening the Control Panel and Bracket Mounting
A. Mounting surface
B. Back unit
To Mount the Unit:
1. Release the screws
2. Remove the front cover
3. Mark 4 drilling points on the mounting surface
4. Drill 4 holes and insert wall anchors
5. Fasten the back unit with 4 screws
8
1
A
4
Figure 3.1 – Back Unit Mounting
A
B
3
A
5
D-303145