Visonic PowerMaster-10 Installer's Manual page 50

13.
2nd private tel#
14.
3rd private tel#
15.
16.
3rd PRIVATE TEL. NO.
17.
3rd private tel#
18.
4th private tel#
19.
20.
4th PRIVATE TEL. NO.
21.
4th private tel#
22.
Redial attempts
23.
3 attempts
24. or
25.
Redial attempts
26.
Tel. acknowledge
27.
single ack
28. or
29.
Tel. acknowledge
D-303145
Enter the third private telephone number (including area code, if required)
of the private subscriber to which the system will report the event groups.
Enter the fourth private telephone number (including area code, if required)
of the private subscriber to which the system will report the event groups.
Here you determine the number of times the communicator will dial the
called party's number (private telephone).
Select between "1 attempt", "2 attempts", "3 attempts" and "4
attempts".
Attention! A maximum of 2 dialing attempts is permitted by the
Australian Telecommunication Authority.
Here you determine whether the system will use the single acknowledge
or the all acknowledge mode when reporting to private telephones.
Note: In the single acknowledge mode, receiving an acknowledge signal
from a single telephone is sufficient to consider the current event closed
and call off the communication session. The remaining telephones serve
for backup purposes only. In the all acknowledge mode, an acknowledge
signal must be received from each telephone before the current event is
considered reported.
Select between "single ack" and "all ack".
You can now press the
menu (see the next section), or press the
" ".
<OK> TO EXIT
button to revert to the "
button to take you to
"
VOICE REPORT
49