Modifying A Device - Visonic PowerMaster-10 Installer's Manual

ID No. 120-5812
or
6.
Z03:Motion Sens
ID No. 120-3712
7.
(OFF) to delete
8.
MOTION SENSORS

4.5.5 Modifying a Device

Note: Steps 1 to 13 are applicable to detectors only.
D. To Modify a Device
1.
ADD NEW DEVICES
2. or
MODIFY DEVICES
3.
CONTACT SENSORS
4. or
MOTION SENSORS
Z01:Motions Sens
ID No. 120-3712
30
Select the motion sensor to be deleted, for example, "Z03:Motion
Sens".**
* If there are no devices to be deleted, the PowerMaster-10 display
reads "
NO EXISTING DEV.
** The displayed device LED indicator blinks red. You can click the
or
The device is deleted from the PowerMaster-10 system.
You can now press the
procedure to delete another device of the same type, or press the
button to delete a different device, or press the
you to " ".
<OK> TO EXIT
When exiting "
INSTALLER MODE
displays the number of devices that need to be updated, as follows: "
".
UPDATING NNN
Repeat steps 1 to 2 in section 4.5.2 "Adding a Wireless Device".
Select the desired sensor to be modified. Select between "CONTACT
SENSORS", "MOTION SENSORS", "SMOKE SENSORS", "WIRED SENSORS"
"KEYFOBS", "KEYPADS" and "SIRENS" for example, "MOTION SENSORS".
*
"
buttons to select another device of the same type.
button and repeat steps of the above
" menu the PowerMaster-10 system
button to take
DEV
D-303145