Calling Upload/Download Server - Visonic PowerMaster-10 Installer's Manual

The following GSM/ GPRS messages are reported:
Message What is means
Unit is OK GSM / GPRS is functioning correctly.
GSM comm. The
loss GSM/GPRS module
Pin code fail Missing or wrong PIN code.
(Only if SIM card PIN code is enabled.)
GSM net. fail Unit failed with registration to local GSM
network.
SIM card fail SIM not installed or SIM card failure.
GSM not GSM auto enroll failed to detect GSM/GPRS
detected module.
No GPRS The SIM card does not have the GPRS service
service enabled.
GPRS conn. Local GPRS network is not available or, wrong
fail setting to GPRS APN, user and/or password.
Srvr PowerManage cannot be reached
unavailable
IP not Server IP #1 and #2 are not configured.
defined
APN not APN is not configured.
defined
SIM card After entering a wrong PIN code 3 consecutive
locked times the SIM is locked.
Denied by The PowerManage denies the connection
server request.

6 CALLING UPLOAD/DOWNLOAD SERVER

Note:
This option is only used during the installation of panels monitored by compatible Monitoring Stations.
This option allows the installer to initiate a call to the upload/download server. The server uploads the
PowerMaster-10 configuration to its data base and can unload predefined parameters to the PowerMaster-10.
To Perform Server Upload/Download
1.
11:START UL/DL
D-303145
∗ If there are no wireless devices enrolled in the PowerMaster-10
system, the PowerMaster-10 display reads "
** When the
before it is displayed, depending on the severity of the failure.
Clicking the
takes you one level up with each click. Clicking the
take you to "
the procedure will take you to the "
Panel cannot communicate
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
button is pressed the test result takes up to 4 min.
button repeatedly at any stage in the procedure
". Clicking the
<OK> TO EXIT
LAN
Suggested Action
N/A
with Make sure the GSM modem is connected
correctly to the control panel
From the
appropriate PIN code to the SIM card
Wait several minutes and then power up the
system. If this fails refer to the provider
i) Make sure a SIM card is installed.
ii) If so, make sure the SIM card has been
mounted properly.
iii) If so, replace the SIM card
Connect the GSM modem.
Contact GSM provider
Make sure the proper GPRS APN, user name
and password are used
Check the "IP RCVR" menu, or, use a PC to
ping the server to make sure it is accessible.
Check the "IP RCVR" menu
Check the "APN" menu
To unlock it enter a PUK number. The PUK
number
PowerMaster-10.
Check that the Panel is registered to the
PowerManage
PowerManage administrator at the Monitoring
Station.
Refer to
PowerManage user's guide,
".
NO DEVICES
button at the end of
" menu.
"PIN code" menu,
cannot be entered
Receiver. Consult
the enrollment section
button will
enter the
by the
with the
in the
81