Configuring The Jamming Detection; Configuring Whether A Missing Device Causes The System To Become "Not Ready - Visonic PowerMaster-10 Installer's Manual

30:BELL/REP.OPT

4.8.9 Configuring the Jamming Detection

Here you determine whether jamming (interfering transmissions, on the radio channel used by the system) will
be detected and reported or not.
If a jam detection option is selected, the system does not allow arming under the relevant jamming conditions.
Jam Detection Options
Option
UL 20/20
(USA standard)
EN 30/60
(Europe standard)
class 6 (30/60)
(British standard)
Disable (default)
To Configure the Jamming Detection
1.
03:CONTROL PANEL
2.
01:ENTRY DELAY 1
or
3.
19:JAM DETECT
4.
disable
or
5.
6.
19:JAM DETECT
4.8.10 Configuring Whether a Missing Device Causes the System to Become
"NOT READY"
Here you determine if the system will be in NOT READY status when there is a supervision failure. In the "in
supervision" mode, the system will be in NOT READY status if during the last 20 minutes a supervision
message was not received. Options: normal (default) and in supervision.
Note: To comply with EN requirements, "in supervision" must be selected.
60
You can now press the
menu in "
03:CONTROL PANEL
" ".
<OK> TO EXIT
Detection and Reporting when
There is continuous 20 seconds of jamming
There is an accumulated 30 seconds of jamming within 60 sec.
Like EN (30/60) but the event will be reported only if the jamming
duration exceeds 5 minutes.
(No jamming detection and reporting).
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "UL 20/20", "EN 30/60", "class 6 (30/60)" and
"disable".
You can now press the
menu in "
03:CONTROL PANEL
" ".
<OK> TO EXIT
or button to program any other
" or press the
or button to program any other
" or press the
button to take you to
button to take you to
D-303145