Visonic PowerMaster-10 Installer's Manual page 44

9.
IP RCVR 1
10.
IP RCVR 2
11.
000.000.000.000
12.
IP RCVR 2
13.
SMS RCVR1
14.
15.
SMS RCVR1
16.
SMS RCVR2
17.
18.
SMS RCVR2
Compatible Monitoring Station receivers are:
Osborne-Hoffman model 2000, Ademco Model 685, FBII Model CP220, Radionics Model D6500, Sur-
Gard Model SG-MLR2-DG and Silent Knight Model 9500.
IMPORTANT: In telephone number locations and account number locations, you may be required to enter
hexadecimal digits. In telephone number locations, these digits are used as codes to control the dialer:
Hex.Digit Keying
Sequence
⇒
A <#> <0>
⇒
D <#> <3>
⇒
E <#> <4>
⇒
F <#> <5>
Note: A "+" can be entered at the beginning of the line by clicking
D-303145
Here you enter the IP address of the IP receiver that is located in the 2
Monitoring Station.
Enter the IP address of the second IP receiver (for further details see the
table at the end of this section).
Here you enter the telephone number of the SMS receiver that is located
st
in the 1 Monitoring Station.
Enter the telephone number of the first SMS receiver (for further details
see the table at the end of this section).
Here you enter the telephone number of the SMS receiver that is located
nd
in the 2 Monitoring Station.
Enter the telephone number of the second SMS receiver (for further
details see the table at the end of this section).
You can now press the
" menu, or press the
FORMAT
".
EXIT
Code
Significance
Applicable only at the beginning of a number - the dialer waits 10
seconds or waits for dial tone, whichever comes first and then dials.
Applicable only at the beginning of a number - the dialer waits 5 seconds
for dial tone and goes on hook if none is received.
Applicable only in the middle of the number - the dialer waits 5 seconds
Not applicable in phone numbers
button to take you to the "
button to take you to "
and then .
nd
PSTN RPRT
<OK> TO
43