Table of Contents
Advertisement
Key
Functionality
Long press for speed.
Places cursor to extreme right position of edit string and shows the last 16 digits of edit string.
Reverts to previous or top menu without saving the edit string.
Reverts to "<OK> TO EXIT" without saving the edit string.
Saves and reverts to previous menu.
I
OK
Clears all digits to the right of cursor.
Clears one digit by cursor.
Selects between uppercase or lowercase digits.
4.11 CONFIGURING OUTPUT PARAMETERS
4.11.1 Preliminary Guidance
This mode allows you:
a. Events/conditions selection under which PGM (programmable) output will function.
b. Selection of the internal siren or STROBE light (that will be activated according to system programming).
4.11.2 Define PGM
For the PGM output, you can select disable, turn on, turn off or pulse active (turn on for predefined period, selected by
PULSE TIME), as follows:
ARM AWAY (upon AWAY arming).
ARM HOME (upon HOME arming).
DISARM (upon disarming).
MEMORY (activated upon registration of an alarm in the memory, turned off upon memory clearing).
DELAY (during exit / entry delays).
KEYFOB (upon AUX button pressing in the keyfob transmitter).
ZONES (by disturbance in each of 3 selected zones, irrespective of arming / disarming). If you select toggle, the PGM
output will be turned on upon event occurrence in these zones and will be turned off upon next event occurrence,
alternately.
LINE FAIL: PGM output is ON if telephone line is disconnected.
For PGM devices, you can select the following actions:
FLASH ON ALARM - you can select no flash or all light flash, to control PGM lighting devices in alarm conditions.
LOCKOUT TIME - you can enter daytime limits between which PGM lighting devices controlled by sensors will be off,
even when the associated sensors are triggered.
A. To Configure Output Parameters
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
Enter your Installer Code.
3.
The PowerMax10-G2 display will read [NEW INSTL CODE].
Note: The installer code should never be programmed as "0000". Doing so will
lock the user out of the installer menu!
4.
When the PowerMax10-G2 display reads [NEW INSTL CODE] click the
or
button repeatedly until the PowerMax10-G2 display will read
[DEFINE OUTPUTS].
5.
Press the
button.
I
OK
There are two sub-menus [DEFINE PGM] and [PGM GENERAL DEF].
The PowerMax10-G2 display will first read [DEFINE PGM].
6.
When the PowerMax10-G2 display reads [DEFINE PGM], press the
button.
54
button
.
I
OK
INSTALLER MODE
ENTER CODE:
NEW INSTL CODE
DEFINE OUTPUTS
I
OK
READY 00:00
I
OK
CODE
or
I
OK
DEFINE PGM
I
OK
D-302756
Advertisement
Table of Contents
