User Settings; Factory Default; General Guidance - "Factory Default" Menu; Resetting Factory Default Parameters - Visonic PowerMaster-10 Installer's Manual

The following table presents the test result messages
Message
Unit is OK
GSM comm. loss
Pin code fail
GSM net. fail
SIM card fail
GSM not detected
No GPRS service
GPRS conn. fail
Srvr unavailable
IP not defined
APN not defined
SIM card locked
Denied by server

3.10 User Settings

This USER SETTINGS menu provides you with a gateway to the user settings through the regular user
programming menu.
Refer to the User's Guide for detailed procedures.
Caution! If after having programmed the user codes the system does not recognize your installer code,
this indicates you must have programmed a user code that is identical with your installer code. If so,
access the user menu and change the code that is identical with your installer code. This will re-validate
your installer code

3.11 Factory Default

3.11.1 General Guidance – "Factory Default" Menu
The FACTORY DEFLT menu enables you to reset the PowerMaster-10 / PowerMaster-30 parameters to the
factory default parameters. To obtain the relevant parameters defaults, contact the PowerMaster-10 /
PowerMaster-30 dealer.

3.11.2 Resetting Factory Default Parameters

To
reset factory default parameters
Step 1
Select "09:FACTORY [1]
DEFLT" menu
09:FACTORY DEFLT
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
GSM / GPRS is functioning correctly
The GSM/GPRS module does not communicate with the Panel
Missing or wrong PIN code. (Only if SIM card PIN code is enabled.)
Unit failed with registration to local GSM network.
SIM not installed or SIM card failure.
GSM auto enroll failed to detect GSM/GPRS module.
The SIM card does not have the GPRS service enabled.
Local GPRS network is not available or, wrong setting to GPRS APN, user and/or
password.
IPMP Receiver cannot be reached – Check the Server IP
Server IP #1 and #2 are not configured.
APN is not configured.
After entering a wrong PIN code 3 consecutive times the SIM is locked. To unlock it
enter a PUK number. The PUK number cannot be entered by the control panel.
The IPMP denies the connection request. Check that the Panel is registered to the
IPMP
proceed as follows:
Step 2
Select "<OK> to [2]
restore"
<OK> to restore
Description
Step 3
Enter Installer Code [3]
ENTER CODE:
Step 4
Resetting of factory [4]
default parameters is
underway
PLEASE WAIT...
Step 5
To
Step 1
75