Setting The Master Installer Code - Visonic PowerMaster-10 Installer's Manual

A. To Set a New Installer Code
1.
2.
01:INSTALL CODES
NEW MASTER CODE
3.
4.
NEW INST. CODE
5.
INST. CODE
NEW INST. CODE
Note: Installer Code should never be programmed as "0000". Doing so will lock the user out of the installer menu!

4.4.2 Setting the Master Installer Code

For PowerMaster-10 with MASTER INSTALLER code, set a new INSTALLER code as described in section
4.3.1 "Setting a New Installer Code" and set the MASTER INSTALLER code as described in this section.
By using the master installer code, the menu enables changing both master installer code and installer code.
By using the installer code, the menu enables changing the installer code only.
B. To Set a New Master Installer Code
1.
2.
01:INSTALL CODES
NEW MASTER CODE
3.
MASTER CODE
NEW MASTER CODE
4.4.2.1 Identical Installer and Master Installer codes
In a 2-installer code system, the non-master installer may inadvertently change his Installer Code to that of the
Master Installer Code. In this case, the panel will allow the change in order to prevent the non-master installer
from realizing the discovery of the Master Installer's Code. The next time the Master Installer enters the Installer
Mode the Master Installer will be considered as an Installer and not as a Master Installer. In such a case the
Master Installer should use one of the following solutions:
18
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Note: The menu displayed within the dashed box appears only if the control panel
includes the Master Installer Code.
Enter the new 4-digit Installer Code (8888 or 9999) at the position of the
888
blinking cursor and then press
* The default Installer Code is 9999.
If your system uses MASTER CODE, you should proceed to setting the
MASTER INSTALLER code in section 4.4.2 by clicking the
or press the
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Enter the new 4-digit Installer Code (8888 or 9999) at the position of the
999
blinking cursor and then press
* Master Installer Code should never be programmed as "0000". Doing so
will lock the user out of the installer menu!
You can now press the
button to take you to "
.*
button to take you to "
<OK> TO EXIT
.*
button to set the INSTALLER code or press the
".
<OK> TO EXIT
button,
".
D-303145