Defining Defaults; Siren Configuration; Configuring The Length Of Time The Bell Is Allowed To Function - Visonic PowerMaster-10 Installer's Manual

4.5.7 Defining Defaults

Attention! When changing the default parameters of one device in Define Defaults, all new devices of the same
device type that are enrolled in the PowerMaster-10 system will have the same defaults. Devices that were
already enrolled in the PowerMaster-10 system before the procedure was performed will not be affected by the
new default settings.
To Define Device Defaults
1.
02:ZONES/DEVICES
2.
ADD NEW DEVICES
3. or
DEFINE DEFAULTS
4.
CONTACT SENSORS
5. or
6.
KEYFOBS
7.

4.6 Siren Configuration

4.6.1 Configuring the Length of Time the Bell is allowed to Function

Here you select the length of time the bell (or siren) is allowed to function upon alarm. The bell time starts upon
activation of the siren. Once the bell time expires, the siren is automatically shut down.
Available options are: 1, 3, 4 (default), 8, 10, 15 and 20 minutes.
Note: To comply with EN requirements, the Bell Time should be set to 15 min. max.
D-303145
*** If the device was enrolled manually, by entering the ID number, the
PowerMaster-10 display reads "
At the end of the procedure you can press the
the same procedure for a different device of the same type, or you can
press the button to select a different device type to be replaced,
or you can press the
When exiting "
INSTALLER MODE
displays the number of devices that need to be updated, as follows:
" ".
DEV UPDATING NNN
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select the desired device whose defaults you wish to define. Select between
"CONTACT SENSORS", "MOTION SENSORS", "SMOKE SENSORS", "KEYFOBS",
"KEYPADS", or "SIRENS", for example, "KEYFOBS".
For reviewing parameter configurations refer to the device Installation
Instructions in the section "
At the end of the procedure you can press the
perform the same procedure for another device or you can press the
button to take you to "
When exiting "
INSTALLER MODE
displays the number of devices that need to be updated, as follows:
" ".
DEV UPDATING NNN
ID ACCEPTED
button to take you to "
" menu the PowerMaster-10 system
MODIFY DEVICE SETTINGS
".
<OK> TO EXIT
" menu the PowerMaster-10 system
".
button and perform
".
<OK> TO EXIT
".
button and
33