Define Custom Locations; Configuring Output Parameters; Preliminary Guidance - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

4.11 DEFINE CUSTOM LOCATIONS

This mode allows you to define up to 5 locations (in addition to the locations that can be defined in the ZONES /
DEVICES mode - see par. 4.4).
To Define Custom Locations
1.
DEFINE CUSTOM
2.
CUST. ZONES NAME
3.
EDIT USER TERM 1
4.
Custom 1
5.
EDIT USER TERM 1
Key Functionality
Moves the cursor from left to right.
Long press for speed.
Moves the cursor from right to left.
Long press for speed.
Scrolls upward the sequence of inserted digits.
Long press for speed.
Scrolls downward the sequence of inserted digits.
Long press for speed.
Places cursor to extreme right position of edit string and shows the last 16 digits of edit string.
Reverts to previous or top menu without saving the edit string.
Reverts to "<OK> TO EXIT" without saving the edit string.
Saves and reverts to previous menu.
Clears all digits to the right of cursor.
Clears one digit by cursor.
Selects between uppercase or lowercase digits.

4.12 CONFIGURING OUTPUT PARAMETERS

4.12.1 Preliminary Guidance

This mode allows you:
a. Events/conditions selection under which PGM (programmable) output will function.
b. Selection of the internal siren or STROBE light (that will be activated according to system programming).
D-302756
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Enter the first custom location.
Note: The table at the end of this section provides a list of the keys used
by the PowerMaster-10 editor.
Press the or
" - –
USER TERM 2 EDIT USER TERM 5
Pressing the
will take you to "
<OK> TO EXIT
button and repeat the procedure for "
", as required.
or buttons at any stage in the procedure
".
EDIT
57