Visonic PowerMaster-10 Installer's Manual page 4

MESSAGE TO THE INSTALLER
The PowerMaster-10 control panel is supplied with 2 instruction manuals:
Installer's Guide (this manual) – for use of system installer during system installation and configuration
User's Guide -– also for use of system installer during system installation and configuration, but also for the
master user of the system, once installation is completed. Hand this manual over to the master user of the
system.
In addition each device comes with its own installation instructions (both physical installation and its
PowerMaster-10 configuration options).
Appendices A.1 and A.2 of the Installer's Guide will help you prepare an installation plan. Consider filling out the
forms - your job will become much easier and confusion will be prevented. Filling out the forms will also help you
create a list of detectors and transmitters that must be obtained for the particular application.
Although setting the correct time and date is one of the user tasks, we recommend that you set the time and
date in the course of programming. Access to the "User Settings" for the installer is possible from the installer's
menu or through the user menu (see User's Guide section 2).
After programming, proceed to install the system as detailed in the Installation Instructions.
For PSTN systems you should verify the alarm system is able to seize the telephone line in order to provide
timely reports, even in cases where telephone line is being used when alarm occurs.. Be aware of other phone
line services such as DSL. If DSL service is present on the phone line, you must install a filter. It is suggested to
use the DSL alarm filter model Z-A431PJ31X manufactured by Excelsus Technologies, or equivalent. This filter
simply plugs into the RJ-31X jack and allows alarm reporting without breaking the internet connection.
Compliance Statement
Hereby, Visonic Group declares that the PowerG series of central units and accessories are designed to comply
with:
•
U.S. Standards: USA: (FCC) CFR 47part 15 and part 68
•
Canada Standards: RSS 210
•
European CE Standards
The PowerMaster-10 is compatible with the RTTE requirements - Directive 1999/5/EC of the European Parliament
and of the Council of 9 March 1999.
According to the European standard EN50131-1, the PowerMaster-10 security grading is 2 – "low to medium risk"
and environmental classification is II – "indoor general" and the power supply type is A. EN 50131-6
•
GSM standards:
Europe: Complies with CE standards 3GPP TS 51.010-1, EN 301 511, EN301489-7
USA: CFR 47 Part 22 (GSM850) and Part 24 (GSM 1900).
EMC standard: CFR 47 Part 15
D-303145 3