Enabling The Back Light; Configuring The Disarm Option - Visonic PowerMaster-10 Installer's Manual

enable beeps
or
5.
6.
10:PIEZO BEEPS

4.10.3 Enabling the Back Light

Here you determine whether the keypad back lighting will remain on at all times or will turn on when a key is
pressed and turn off within 10 seconds if no further keystrokes are sensed.
The two options are: always ON and OFF after 10 s (default).
To Enable the Back Light
1.
03:CONTROL PANEL
2.
01:ENTRY DELAY 1
or
3.
22:BACK LIGHT
4.
OFF after 10s
or
5.
6.
22:BACK LIGHT

4.10.4 Configuring the Disarm Option

Here you determine when it is possible to disarm the system:
A. Any time.
B. In AWAY mode, during entry delay, by using the PowerMaster-10 keypad or wireless sensor (keyfob).
C. In AWAY mode, during entry delay, by using a wireless device (keyfob) only (this is set as a default in UK to
comply with DD243).
D. During entry delay, or by using the PowerMaster-10 keypad in AWAY mode.
Options: any time (default), on entry wireless, entry + away kp (default in UK), or on entry all.
To Configure the Disarm Option
1.
03:CONTROL PANEL
2.
01:ENTRY DELAY 1
D-303145
Select between "enable beeps", "off when home" and "disable
beeps".
You can now press the
menu in "
03:CONTROL PANEL
" ".
<OK> TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "OFF after 10s", and "always ON".
You can now press the
menu in "
03:CONTROL PANEL
" ".
<OK> TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
or button to program any other
" or press the
or button to program any other
" or press the
button to take you to
button to take you to
67