Testing One Device - Visonic PowerMaster-10 Installer's Manual

5.1.2 Testing One Device

1.
07:DIAGNOSTICS
2.
WL DEVICES
3.
TEST ALL DEVICES
4.
TEST ONE DEVICE
5.
CONTACT SENSORS
or
6.
MOTION SENSORS
7.
Zxx:Motion Sens
Front door
or
8.
TESTING Zxx 001
or
ACTIVATE NOW Uxx
Z01 NOW: STRONG
Z01 24Hr: EARLY
78
At the end of the testing procedure the PowerMaster-10 display will read
" ".
SHOW ALL DEVICES
∗ If there are no wireless devices enrolled in the PowerMaster-10
system, the PowerMaster-10 display reads "
Clicking the
to " " alternating with "
<NEXT> TO END
button at any stage in the procedure will take you to "
".
EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "CONTACT SENSORS", "MOTION SENSORS", "SMOKE
SENSORS", "KEYFOBS", "KEYPADS", "SIRENS" or "REPEATERS", for
example, "MOTION SENSORS".
The PowerMaster-10 display will read the device name alternating with
the location.
(press the or
The PowerMaster-10 display will read "TESTING Zxx 001" or
"ACTIVATE NOW Uxx" for keyfobs.
After testing the PowerMaster-10 display will then automatically change
to read the average level for the last 24 hours (for stationary devices) or
the number of activations that the control panel has received (for
keyfobs).
button at any stage in the procedure will take you
<OK> TO CONTINUE
button to select another enrolled device.)
".
NO DEVICES
". Clicking the
<OK> TO
D-303145