Visonic PowerMaster-10 Installer's Manual page 43

3.
1st RCVR ACC. NO.
4.
RCV 1 ACCOUNT#
5.
RCV 2 ACCOUNT#
6.
2nd acc. #001234
7.
2nd RCVR ACC. NO.
8.
RCV 2 ACCOUNT#
4.7.3.4 Configuring the Monitoring Station's Telephone Numbers and IP Addresses
This mode allows you to adapt the telephone communication parameters to the local requirements.
Continue below from the previous section or repeat steps 1 to 4 of section 4.7.3.1 before continuing with the
following instructions:
REPORT EVENTS
or
1.
PSTN/GSM RCVR 1
2.
3.
PSTN/GSM RCVR 1
4.
PSTN/GSM RCVR 2
5.
6.
PSTN/GSM RCVR 2
7.
IP RCVR 1
8.
000.000.000.000
42
Enter the first receiver account number.
Here you enter the number that will identify your system to the 2
Monitoring Station. The account number consists of 6 hexadecimal digits.
Enter the second receiver account number.
You can now press the
" menu, or press the
RCVR 1
".
EXIT
Here you program the telephone number of the 1
(including area code, 16 digit max.) to which the system will report the
event groups defined in Report Events.
Enter the telephone number of the first PSTN/GSM receiver (for further
details see the table at the end of this section).
Here you program the telephone number of the 2
(including area code, 16 digit max.) to which the system will report the event
groups defined in Report Events.
Enter the telephone number of the second PSTN/GSM receiver (for
further details see the table at the end of this section).
Here you enter the IP address of the IP receiver that is located in the 1
Monitoring Station.
Enter the IP address of the first IP receiver (for further details see the
table at the end of this section).
button to take you to the "
button to take you to "
st
Monitoring Station
nd
Monitoring Station
nd
PSTN/GSM
<OK> TO
st
D-303145