Programming; General Guidance; Entering The Installer Menu; Installer Mode Options Menu - Visonic PowerMaster-10 Installer's Manual

4. PROGRAMMING

4.1 General Guidance

We recommend programming the PowerMaster-10 on the work bench before actual installation. Operating
power may be obtained from the backup battery or from the AC power supply.

4.2 Entering the Installer Menu

The following procedure describes how to enter the Installer Menu.
To Enter the Installer Menu
READY 00:00
1.
INSTALLER MODE
2.
ENTER CODE:
3. CODE
01:INSTALL CODES
or
4.
02:ZONES/DEVICES

Installer Mode Options Menu

Click the button until the display reads the desired setting option and then press the
01:INSTALL CODES
02:ZONES/DEVICES
03:CONTROL PANEL
04:COMMUNICATION
05:OUTPUTS
06:CUSTOM CUSTOM
07:DIAGNOSTICS
D-303145
Make sure the system is disarmed and then press the
repeatedly until the PowerMaster-10 display reads "INSTALLER MODE".
Enter your Installer Code.
Press the or
desired setting option, for example, "ZONES/DEVICES".
You can program any other menu or press the
take you to "
<OK> TO EXIT
Use to program the Installer Code and the Master Installer Code. See
section 4.4.1
Use to Add, Delete, Configure, Replace and Configure devices and also to
define your personal set of Defaults for device configuration. See section 4.5.
Use to define control panel parameters. See sections 4.6, 4.8, 4.9 and 4.10.
Use to define control panel communication parameters. See section 4.7.
Use to define the PGM output. See section 4.12.
Use to define custom zone names. See section 4.11.
Use to test and identify devices and wireless communication link quality. See
button repeatedly until the display reads the
".
button
or buttons to
button.
15