Visonic PowerMaster-10 Installer's Manual page 41

The selectable options are as follows:
Plan name
"all -o/c
backup"
"all
all"
"all-o/c all -o/c "
"all –o/c o/c "
"all (–alrt)
alrt"
"alrm
all (–alrm)"
"disable report"
"all
backup"
Note: "All" means that all 4 groups are reported and also trouble messages - sensor / system low battery, sensor
inactivity, power failure, jamming, communication failure etc.
4.7.3.1 Configuring the Types of Events to be Reported
1.
04:COMMUNICATION
2.
1:PSTN/GSM
or
3.
3:C.S. REPORTING
4.
REPORT EVENTS
5.
all-o/c*backup
or
6.
7.
REPORT EVENTS
4.7.3.2 Configuring the Communicators Report Sequence
Continue below from the previous section or repeat steps 1 to 4 of section 4.7.3.1 before continuing with the
following instructions:
REPORT EVENTS
1.
1st RPRT METHOD
2.
disable
3. or
4.
40
Sent to center 1
All but open/close
All
All but open/close
All but open/close
All but alerts
Alarms
Nothing
All
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "all-o/c* backup", "all
o/c*all-o/c",
"alrm*all(-alrm)", "disable report" and "all
You can now press the
" menu, or press the
METHOD
".
EXIT
Here you define the 1st priority of method used to report events.
Select between "disable", "cellular" and "PSTN".
Sent to center 2
All but open/close if center 1 doesn't respond
All
All but open/close
Open/close
Alerts
All but alarms
Nothing
All if cent. 1 doesn't respond
"all-o/c*o/c",
button to take you to the "
button to take you to "
*all", "all-
"all(-alrt)*alrt",
*backup".
1st RPRT
<OK> TO
D-303145