Visonic PowerMaster-10 Installer's Manual page 28

PERFORM STEPS 1, 2 & 3 ON A WORKBENCH BEFORE THE MOUNTING
1
4
7
1. Extract either plastic segment (will be used later)
2. Extract plastic segment (will be used later)
3. Extract plastic segment (left or right, according to the power wiring direction)
4. Remove power supply terminals cover
5. Insert power cable and connect it to the Power Supply Unit terminals.
Verify that the wires are properly fastened!
6. Insert plastic cap to the power cable entry (extracted in step 1)
7. Fasten power cable by clamp (extracted in step 2)
8. Close power supply terminals cover
A. Power supply module
B. Power cable clamp options
C. For thin cable
D. For thick cable (reversed clamp)
E. Terminals cover
D-303145
POWER CABLE ROUTING
2
5
B
C D
Figure 4.3 – Power Cable Wiring
3
6
A
8
E
27