Extreme Networks Summit WM3000 Series Reference Manual page 92

Network Setup
2 In the Destination Subnet field, enter an IP address to route packets to a specific destination address.
3 Enter a subnet mask for the destination subnet in the Subnet Mask field.
The Subnet Mask is the IP mask used to divide internet addresses into blocks known as subnets. A
value of 255.255.255.0 support 256 IP addresses.
4 In the Gateway Address field, enter the IP address of the gateway used to route the packets to the
specified destination subnet. Do not set the gateway address to any VLAN interface used by the
controller.
5 Refer to the Status field for the current state of the requests made from applet. This field displays
error messages if something goes wrong in the transaction between the applet and the controller.
6 Click OK to use the changes to the running configuration and close the dialog.
7 Click Cancel to close the dialog without committing updates to the running configuration.
92
Summit WM3000 Series Controller System Reference Guide