Extreme Networks Summit WM3000 Series Reference Manual page 102

Network Setup
4 Enter the VLAN ID for the controller virtual interface.
5 Provide a Description for the VLAN, representative of the VLAN's intended operation within the
controller managed network.
6 The Primary IP Settings field consists of the following:
a Select Use DHCP to obtain IP Address automatically to allow DHCP to provide the IP address for
the virtual interface. Selecting this option disables the IP address field.
b Enter the IP Address for the VLAN associated virtual interface.
c Enter the Subnet Mask for the IP address.
7 Select the Set as Management Interface checkbox to enable any host displayed in this VLAN to
configure the controller.
NOTE
Only one virtual interface can be set as the management interface.
8 Use the Secondary IP Addresses field to define additional IP addresses to associate with VLAN IDs.
The address provided in this field is used if the primary IP address is unreachable.
Select the Add button (within the Secondary IP Addresses field) to define additional addresses from
a sub screen. Choose an existing secondary address and select Edit or Delete to revise or remove a
secondary address. The secondary address must be on a different subnet of the primary IP address.
9 Refer to the Status field for the current state of the requests made from applet. This field displays
error messages if something goes wrong in the transaction between the applet and the controller.
10 Click OK to use the changes to the running configuration and close the dialog.
11 Click Cancel to close the dialog without committing updates to the running configuration.
102
Summit WM3000 Series Controller System Reference Guide