Extreme Networks Summit WM3000 Series Reference Manual page 79

controller was booted, the updated version is uploaded to the controller the next time the controller is
booted. Enable this option for either the firmware, configuration file or cluster configuration file.
Extreme Networks recommends leaving this setting disabled if a review of a new file is required before
it is automatically uploaded by the controller.
To enable and configure the automatic update feature for controller firmware, configuration files and
cluster configurations:
1 Select Controller > Automatic Updates from the main menu tree.
2 Refer to the Controller Configuration field to enable and define the configuration for automatic
configuration file updates. If enabled, the located (updated) configuration file will be used with the
controller the next time it boots.
Enable
IP Address
User ID
File Name
(With Path)
Summit WM3000 Series Controller System Reference Guide
Enable
Select the checkbox to allow an automatic configuration file
update when a newer (updated) file is detected (upon the boot of the
controller) at the specified IP address.
Define the IP address of the server where the configuration files reside. If
a new version is detected when the controller is booted, it is uploaded to
the controller and used upon the next boot of the controller.
User ID
Enter the required to access the FTP or TFTP server.
Provide the complete and accurate path to the location of the
configuration files on the server. This path must be accurate to ensure
the most recent file is retrieved.
79