Extreme Networks Summit WM3000 Series Reference Manual page 110

Network Setup
The Configuration tab displays the following details:
Index
Enabled
ESSID
Description
VLAN(s)
Authentication
110
Displays the WLAN's numerical identifier. The WLAN index range is from
1 to the maximum number of WLANs supported by the controller (32 for
the WM3600 and 256 for the WM3700). An index can be helpful to
differentiate a WLAN from other WLANs with similar configurations.
Refer to the Enabled parameter to discern whether the specified WLAN is
enabled or disabled. When enabled, a green check mark displays. When
disabled, a red "X" displays. To enable or disable a WLAN, select it from
the table and click the Enable or Disable button.
Displays the Service Set ID associated with each WLAN. Click the Edit
button to modify the value to a new unique SSID.
Displays a short description of the associated WLAN. Click the Edit
button to modify the value the WLAN description.
Displays the name of the VLAN ID(s) of the VLAN(s) this WLAN is
mapped to. The VLAN ID can be between 1 and 4094. The default
mapping is to a single VLAN with VLAN ID 1.
Displays the type of authentication used with the specified WLAN. Click
the Edit button to modify the WLAN's current authentication scheme. For
information on configuring an authentication scheme for a WLAN, see
a cluster environment with multiple controllers, please ensure that the
VLAN list is consistent across all controllers." on page 119.
Summit WM3000 Series Controller System Reference Guide
"In