Extreme Networks Summit WM3000 Series Reference Manual page 305

2 Select the Aeroscout tab.
3 Check the Enable checkbox to globally enable Aeroscout RTLS support on the controller.
This takes effect immediately when the box is checked.
4 Enter the Multicast MAC Address used for all Aeroscout tags to send updates via multicast to the
MAC address specified. Typically the MAC address will start with 01-0C-CC-XX-XX-XX.
NOTE
To use the onboard SOLE engine to locate Aeroscout tags, site parameters, AP location (Command Line Interface
only) and Zone configuration (optional, Command Line Interface only) must be configured.
5 Click the Apply button to save the Multicast MAC Address value.
6 Click the Revert button to cancel any changes made within Multicast MAC Address value and revert
back to the last saved configuration.
7 If the Multicast MAC Address is configured and Aeroscout support is enabled the following
information will be displayed:
IP Address
Port
8 To use the onboard SOLE engine to locate Aeroscout tags check the Enable checkbox. This is enabled
immediately after checking the box.
9 If the onboard SOLE engine is enabled to locate Aeroscout tags, enter a Locate Interval in seconds to
specify how often the known tags are located by the SOLE engine.
Summit WM3000 Series Controller System Reference Guide
Displays the IP address of the external Aeroscout RTLS engine.
Displays the port number which the controller uses to connect to the
external Aeroscout RTLS engine.
305