Extreme Networks Summit WM3000 Series Reference Manual page 307

2 Select the Ekahau tab.
3 Check the Enable checkbox to globally enable Ekahau support on the controller. This takes effect
immediately when the box is checked.
4 Enter the Multicast MAC Address used for all Ekahau tags to send updates via multicast to the MAC
address specified. Typically the MAC address will start with 01-0C-CC-XX-XX-XX.
NOTE
To use the onboard SOLE engine to locate Ekahau tags, site parameters, AP location (Command Line Interface
only) and Zone configuration (optional, Command Line Interface only) must be configured.
5 Specify the IP Address of the Ekahau RTLS engine server.
6 Enter the Port number used to communicate with the Ekahau RTLS engine. The port range must be
between 1000 and 9000.
7 Click the Apply button to save the Multicast MAC Address, IP Address and Port information
8 Click the Revert button to cancel any changes made within Multicast MAC Address, IP Address and
Port settings and revert back to the last saved configuration.
9 If the Multicast MAC Address, IP Address and Port values are configured and Ekahau RTLS support is
enabled the following information will be displayed:
IP Address
Port
Summit WM3000 Series Controller System Reference Guide
Displays the IP address of the external Ekahau RTLS engine.
Displays the port number which the controller uses to connect to the
external Ekahau RTLS engine.
307