Extreme Networks Summit WM3000 Series Reference Manual page 473

1 Select Diagnostics > Ping from the main menu.
2 Refer to the following information displayed within the Configuration tab:
Description
Destination IP
Timeout (sec)
No. of Probes
Frequency
3 To edit the properties of an existing ping test, select a ping based on the description listed and click
the Edit button. For more information, see
on page 474.
4 Select an existing ping test from those displayed within the Configure tab and click the Delete button
to remove the ping test from those displayed.
5 Click the Add button to display a screen used to define the attributes of a new ping test. For more
information, see "Adding a New Ping Test" on page
Summit WM3000 Series Controller System Reference Guide
Displays the user assigned description of the ping test. The name is read-
only. Use this title to determine whether this test can be used as is or if
a new ping test is required.
Displays the IP address of the target device. This is the numeric
destination for the device sent the ping packets. If this address does not
accurately reflect the ping destination target, the ping test will not be
successful.
Displays the timeout value (in seconds) used to timeout the ping test if a
round trip packet is not received from the target device.
Displays the number of packets transmitted to the target IP address to
discern the round trip time between the controller and its connected
device.
Define the interval (in seconds) between ping packet transmissions.
Define a longer interval if high levels of network congestion are
anticipated between the controller and its target device. Use a value of 0
to execute a single ping test or stop a currently executing ping test.
"Modifying the Configuration of an Existing Ping Test"
475.
473